Meet the Ami-Stand — a display base that lifts your finished amigurumi off the shelf and shows them off the way they deserve.
Each base is an original design, modeled by the artist and printed in house. Assembly takes seconds: the post presses into the base with a friction fit, no tools required. Add a drop of super glue if you'd like it permanent.
The 3mm post slides between stitches rather than through them, so it won't leave a hole or damage your work. Fully removable and reusable — swap the same stand between plushies whenever you like.
Details:
Base: ~3–4" wide (varies by design), ~0.8" tall
Post: 4" total length, ~3.5" exposed once inserted
3mm diameter with a smooth tip — parts stitches without snagging or splitting yarn
Ships flat, friction fit, no glue necessary
Choose your base design from the dropdown
Note: 3D printed in PLA. Light layer lines are part of the process and slight color variation may occur between batches. PLA softens in heat — keep out of hot cars, direct sun, and closed vehicles.
⚠️ Choking Hazard: Small parts. Not suitable for children under 3 years.
